Specifications Our Fingertech Blade Mount is the easiest way to attach a blade to a D28xx brushless outrunner motor. Uses four 6-32 screws to mount the blade solidly against the motor body. Fits over the shaft and hub of a D28xx motor. Uses three M2x12mm countersunk screws to mount solidly against the motor body. Four 6-32 threaded holes follow the mounting pattern for all of our spinner blades. Specifications: Material: Anodized 6061 aluminum for high strength and low weight. Hub diameter: 26mm (1in) Hub height: 12mm (0.47in) Blade mount screws: 6-32 at 20mm (0.78″) between centers. Fits all of our spinner blades. Motor shaft diameter: 4mm (0.157in), but works fine with smaller shafted motors. Three hole motor mount pattern: 10.4mm (0.41in) between centers. Weight: 5.9g (0.21oz) Installation Tips: If you don’t have three M2x12mm countersunk screws, a 6-32 setscrew or screw can be used in the threaded side-hole to press into the motor’s setscrew and hold tightly. Note that our D2822 motor with 4mm Shaft does include these screws for you. Use threadlock on all screws. You do not want your blade coming off! As with anything related to combat robots, it is POTENTIALLY DANGEROUS to add a spinning weapon to a robot. NEVER power up the robot outside of a safety enclosure. Always use a safety lock and follow proper activation procedure. Blades: Bloodsport Blade Viper Asymmetrical Titanium Blade Viper Horizontal Spinner Titanium Blade See PDF here:
